Page 1 of 1
Auto square wiring using ClearPath motors on AcornSix
Posted: Mon Oct 31, 2022 5:19 am
by bleiler60
Hello,
Is the wiring for Auto squaring, using ClearPath SDSK motors (jumper between Master & Slave) any different than the previous Acorn board?
Thanks
Bill
Re: Auto square wiring using ClearPath motors on AcornSix
Posted: Mon Oct 31, 2022 7:52 am
by Gary Campbell
There is no jumper involved. Your 4th motor drive channel will simply be slaved to either the 1st or 2nd in the Config Wizard page
Re: Auto square wiring using ClearPath motors on AcornSix
Posted: Mon Oct 31, 2022 3:20 pm
by Centroid_Tech2
No the Auto-squaring enable jumper isn't necessary with the AcornSix board as the enable signals are handled slightly different than on the Acorn.
You can follow schematic s15145 for connecting ClearPath motors to AcornSix.
http://192.168.0.238/schematics/uploads/S15145.r2.pdf
Re: Auto square wiring using ClearPath motors on AcornSix
Posted: Mon Oct 31, 2022 5:13 pm
by gerald martin
@centroid_tech2 I think you will need to put a public URL there for forum users to access
Re: Auto square wiring using ClearPath motors on AcornSix
Posted: Mon Oct 31, 2022 7:58 pm
by cnckeith
Re: Auto square wiring using ClearPath motors on AcornSix
Posted: Mon Oct 31, 2022 7:59 pm
by cnckeith
click.
https://www.centroidcnc.com/centroid_di ... browse.php#
type in the search bar "acornsix" to see all acornsix schematics
type in acornsix clearpath to see clearpath schematic
or type in the schematic number
Re: Auto square wiring using ClearPath motors on AcornSix
Posted: Mon Oct 31, 2022 11:05 pm
by bleiler60
Thank you all
