Spindle Benchtest
Moderator: cnckeith
-
- Posts: 16
- Joined: Thu Dec 16, 2021 9:24 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: Yes
Spindle Benchtest
Started the benchtest went through the steps and got a error for not setting the max spindle speed to 3000, Changed it to 3000 restarted cnc12 and tried to run the test agiain is says (Bench test appears to be partially completed) So I pressed 1 to continue and I get a (Block N4 not found line 67) I do a press 0 to start over and I get the same Block not found message and I cant get pass this, cycled acorn and restarted cnc12 and get the same message
- Attachments
-
- report_E0623464B717-0628226384_2022-09-30_07-51-09.zip
- (781.34 KiB) Downloaded 3 times
-
- Posts: 7325
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Contact:
Re: Spindle Benchtest
Press zero to start over.
Set your minimum speed as well.
Set your minimum speed as well.
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html