I recently upgraded from X and Y lead screws which used screw compensation to X and Y ball screws. I redid my screw compensation tables and turned on the X table. Regardless of the value in the table for 1", I see no change in the measured error at this position. I am able to tune X backlash and it works fine.
I do run Home after all changes to the table and to backlash.
One thing that is new is my version of CNC12.
Does anyone use screw compensation with the newest version of the software?
Thanks,
Rick
Screw Mapping
Moderator: cnckeith
-
- Posts: 150
- Joined: Sat May 27, 2017 2:12 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 38D269533454-0111180523
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Phoenix, AZ
- Contact:
Screw Mapping
- Attachments
-
- report_38D269533454-0111180523_2022-09-20_05-37-00.zip
- X screw compensation should be enabled
- (933.55 KiB) Downloaded 14 times
-
- Posts: 7164
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Contact:
Re: Screw Mapping
rick,
hello.
there have been no changes in screw comp in v4.80 works the same as in v4.64 -k
hello.
there have been no changes in screw comp in v4.80 works the same as in v4.64 -k
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
-
- Posts: 150
- Joined: Sat May 27, 2017 2:12 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 38D269533454-0111180523
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Phoenix, AZ
- Contact:
Re: Screw Mapping
Thanks Keith. Then it is either my new hardware or Senioritis.
Rick
Rick