Keep randomly getting error 9031 DRIVE FAULT! despite there not actually being a drive fault.
I am using the CNC4PC board with clearpath if that matters.
I would like to just disable that error from happening, because it seems to be happening erroneously and is annoying.
what parameter do i change to disable that fault?
Thanks!
how do you disable error 9031 Drive Fault! ?
Moderator: cnckeith
-
- Posts: 2179
- Joined: Sat Nov 18, 2017 2:32 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: Acorn 238
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Marquette, MI
- Contact:
Re: how do you disable error 9031 Drive Fault! ?
You have one input set as DriveOk. Drag it back to the column on the left
-
- Posts: 728
- Joined: Mon Feb 19, 2018 2:52 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 38D269594F9C-0110180512
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: UK
- Contact:
Re: how do you disable error 9031 Drive Fault! ?
(within the setup wizard, "inputs" section - Utilities > Wizard etc).Gary Campbell wrote: ↑Tue Sep 06, 2022 9:09 pm You have one input set as DriveOk. Drag it back to the column on the left
-
- Posts: 25
- Joined: Wed Jan 26, 2022 4:53 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: Yes
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: how do you disable error 9031 Drive Fault! ?
I have the same setup, and was getting the same errors. For me it was always happening, but only when the slaved axis was enabled by the jumpers on the card.
When I dropped the hardware slaving on the cnc4pc card and instead paired axis A in the acorn wizard, it works fine without errors..
When I dropped the hardware slaving on the cnc4pc card and instead paired axis A in the acorn wizard, it works fine without errors..