New user comms error <set ip address >

[DavidCNC1964]

Hello all,
I am trying to bench test my newly purchased acorn board. I am struggling to get the PC and Board to communicate correctly. The ping test results are confusing me. See photo.

I have checked and confirmed that the firewall etc are all switched off.
I have swapped the ethernet cable.

Any suggestions on what I could try next?

TIA David.

[carbuthn]

Try searching for communication problems. There are post in this section. See also https://centroidcncforum.com/viewtopic.php?f=61&t=1451

[DavidCNC1964]

Hi, I have sorted this out now and normal comms have been established. During the initial set up I inadvertently assigned the static IP address to the wrong Ethernet adapter. I went on to assign the static IP (10.168.41.1) to the correct adapter without correcting my original error. Therefore, I introduced a clash. I changed the incorrect address to an alternative and the problem was sorted.
Happy days.

[cnckeith]

glad you figured it out.. also new for v4.80 is the next level com test.. 'stressTest.cnc' located in the ncfiles directory. run that to confirm you really have a good connection.