yep.. these should be at 3200 steps per rev if on a router and 8000 steps per rev if on Mill or Lathe. at the 1500 setting you are shooting yourself in the foot.TCandee wrote: ↑Tue Aug 02, 2022 7:53 pm The leadshine easy servos I have are as follows:
X and Y: ES-MH334480 servo and ES-DH2306 Drive
Z: ES-MH342200 and ES-DH2306
I will look into changing the settings.
CNCSNW, thank you very much!!!
This is a spindle lock for a PDB. It has caught me several times when I forgot to unlock it after a tool change. Wish I could figure out how to make it check this when the spindle is turned on from the VCP or MPG.
set the step per rev on the drive dip switches or with the Leadshine software and set the wizard to match.
set turns ratio to 1 turn per inch, command to move 1" in MDI verify motor rotates 1 turn. if so, then set the overall turns ratio for the machine. these steps are outlined in the Acorn Installation manual and more info link to the discussion thread i provided above.