CNC12 not Homing (Resolved)

[bevins]

I dont know what I did but it was homing correctly.
Now it doesnt say "MAchine not homed" when I start up and when I press cycle start it does nothing.

I can jog it around no problem, can even run a program. But I cannot get it to home.

I put an axis on a home switch and the cncm.hom is suppose to say clear it then rerun. IT doesnt so
it is not reading the cncm.hom.

Please help.

Bob

[bevins]

Rebuilt the config and it is working. Bizare.....

[cnckeith]

for the home message to appear, power cycle the Acorn board.

you can also use the rehome button on the VCP to force the homing cycle without a reboot.

or you can press F2 load and navigate to the cncm.hom file and run it like any other g code job.