Re: Spindle Motor on PM-30MV Integration into Acorn
Posted: Wed Jan 26, 2022 10:30 am
Yes, I have a 2.2kw Delta EL VFD on my beltgrinder, it limits output amps, but if you can not bring 18.5 A to the Baldor, torque will be less also...
My JMC servo with driver and wiring for 559€ and build in resistor can go with 0.2 s acceleration and deceleration time. Thats way faster the Delta can do, but no resistor here, maybe I add one.
For me the JMC sounds still as the best drive to have high power with small weight for a dynamic moving Z-axis...
... maybe a Kollmorgen Servo with higher speed rating, but also very expensive.
Uwe
My JMC servo with driver and wiring for 559€ and build in resistor can go with 0.2 s acceleration and deceleration time. Thats way faster the Delta can do, but no resistor here, maybe I add one.
For me the JMC sounds still as the best drive to have high power with small weight for a dynamic moving Z-axis...
... maybe a Kollmorgen Servo with higher speed rating, but also very expensive.
Uwe