CNC Lathe Part Off tool thickness
Moderator: cnckeith
-
- Posts: 35
- Joined: Wed Apr 21, 2021 7:12 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 4519
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
CNC Lathe Part Off tool thickness
I did a few searches and could not find this topic. I setup my tool offsets following CncKeiths video. Works very well. My question is what is the best way to accommodate the part off thickness?
-
- Posts: 3096
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
Re: CNC Lathe Part Off tool thickness
When you do your tool offsets, you can add in the tool width at that time (I.e. touch off on the back side of the tool, or touch off on the front and add the width to te Z offset). Or, you can add the width in the program when you use that tool by adding the tool width to the part dimension.
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
-
- Posts: 35
- Joined: Wed Apr 21, 2021 7:12 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 4519
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: CNC Lathe Part Off tool thickness
That’s what i was planning to do. Add the width to tool offset/touch the backside. Wasn’t sure if there was something else I was overlooking. Thanks Tom