All things related to the Centroid Acorn CNC Controller
Moderator: cnckeith
ShawnM
Posts: 2234 Joined: Fri May 24, 2019 8:34 am
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: 7804734C6498-0401191832
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
Location: Clearwater, FL
Post
by ShawnM » Tue Jul 19, 2022 12:24 pm
davidmunson wrote: ↑ Tue Jul 19, 2022 12:13 pm
Thanks.. Do I need to put the resistors on the acorn board?
No, you do not. But you need to determine if they are NO or NC switches and change the settings in the wizard accordingly. Normally closed switches are preferred (but not required) for home/limit switches.
Again, take the time and identify all extra wires before you just start hooking them to your Acorn.
Last edited by
ShawnM on Tue Jul 19, 2022 7:40 pm, edited 1 time in total.
Upnorth
Posts: 237 Joined: Wed Apr 01, 2020 8:23 am
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: 1702
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
Post
by Upnorth » Tue Jul 19, 2022 6:06 pm
Do you have mechanical or proximity sensors for your limit switches?
davidmunson
Posts: 39 Joined: Fri Mar 30, 2018 2:21 am
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC11: No
CPU10 or CPU7: No
Post
by davidmunson » Fri Jul 22, 2022 12:08 pm
proximity..
Upnorth
Posts: 237 Joined: Wed Apr 01, 2020 8:23 am
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: 1702
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
Post
by Upnorth » Fri Jul 22, 2022 1:29 pm
Ok I also have a Novakon NM-200 converted to acorn and I did not use the resistors on my proximity sensors.
cnckeith
Posts: 7334 Joined: Wed Mar 03, 2010 4:23 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: Yes
CNC Control System Serial Number: none
DC3IOB: Yes
CNC11: Yes
CPU10 or CPU7: Yes
Contact:
Post
by cnckeith » Mon Jul 25, 2022 10:23 am