E stop gecko 540
Moderator: cnckeith
-
- Posts: 4
- Joined: Mon Nov 22, 2021 1:46 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
E stop gecko 540
Wired e stop as per gecko drive only schematic , with stop in nc position g540 green lite on controller , but acorn screen shows red estop . Push e stop in , showes red on g540 , green on acorn screen , no jogging in either condition . New install
-
- Posts: 120
- Joined: Tue Sep 28, 2021 6:26 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
Re: E stop gecko 540
Invert the estop input on the Acorn
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
https://www.centroidcnc.com/centroid_di ... _gear.html
-
- Posts: 4
- Joined: Mon Nov 22, 2021 1:46 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: E stop gecko 540
Problem was that the e stop switch had 1-no 1 nc switches on it , instead of 2 nc switches.
-
- Posts: 120
- Joined: Tue Sep 28, 2021 6:26 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
Re: E stop gecko 540
Odd but OK. I guess that gives you an "either or" choice for a PLC input but I'll always be in the NC camp. If a wire breaks or device fails, it's a fault condition.
Thanks for posting. That may help somebody else in the future.
Thanks for posting. That may help somebody else in the future.
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
https://www.centroidcnc.com/centroid_di ... _gear.html