Initial setup questions...
Posted: Fri Dec 03, 2021 2:36 am
Hello,
I have 4 Clearpath SD motors and got them configured with MSP, but now I am lost...
I have read the manual and still don't get it on how to do basic things...
- How do I configure the A axis ratio? Should be 6:1
I was able to enable the A axis and do have the F6 command available to turn it on or off... When I go MDI the A axis is way off....
- I have loaded the configuration of the ClearPath SD and I have set in the wizard the CP motors to 1600 per the instructions as well on the MSP from Teknic.
I am looking for direction here because I am completely lost to get the CNC move the correct amount of distance and rotation. Feeling frustrated to say the least and I do have the Pro license.
I have 4 Clearpath SD motors and got them configured with MSP, but now I am lost...
I have read the manual and still don't get it on how to do basic things...
- How do I configure the A axis ratio? Should be 6:1
I was able to enable the A axis and do have the F6 command available to turn it on or off... When I go MDI the A axis is way off....
- I have loaded the configuration of the ClearPath SD and I have set in the wizard the CP motors to 1600 per the instructions as well on the MSP from Teknic.
I am looking for direction here because I am completely lost to get the CNC move the correct amount of distance and rotation. Feeling frustrated to say the least and I do have the Pro license.