Page 1 of 1
CNC12 Settings
Posted: Thu Dec 02, 2021 10:22 am
by slice
New to CNC12 mill, I did search here as well as in the manual.
Is there a way to only have 3 digits shown behind the decimal in the dro?
Is there an indication on the display to show whether absolute or incremental positioning is in use?
Re: CNC12 Settings
Posted: Thu Dec 02, 2021 10:58 am
by centroidsupport
If you change to metric units, the DRO will change to 3 places of precision. Other than that, I don't believe it's possible but it is currently "on the drawing board" for a future release.
Set parameter 46 to 0 for a display of active g codes. It will display g90 in absolute and g91 when in incremental
Re: CNC12 Settings
Posted: Thu Dec 02, 2021 11:55 am
by tblough
Right now, your only choices are 4 or 5 digit precision. See Parameter 143.
Re: CNC12 Settings
Posted: Thu Dec 02, 2021 12:44 pm
by Gary Campbell
Upcoming future versions will have a Wizard setting on the Control page to do just this. Should be out in the near future.
Definition: Near Future: Sometime between this afternoon and a year