Hi everyone,
I am attaching a laser to my router. When I go a M37 the spindle will start spinning and I will get nothing from the laser. As far as I can tell I set everything up correctly. Any advise would be great.
Router + Laser
Moderator: cnckeith
-
- Posts: 95
- Joined: Sat Oct 10, 2020 4:32 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 3699, 3788
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Router + Laser
- Attachments
-
- report_E415F6F96E67-1005203788_2021-12-01_16-35-26.zip
- (698.25 KiB) Downloaded 56 times
-
- Posts: 667
- Joined: Fri Nov 30, 2018 1:04 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Thorp WI
Re: Router + Laser
It looks like you have the outputs in the wizard set up right. Double check your output/relay connections for your type of laser. M37 should turn off the spindle, set 0 rpm, and turn on Output 4 (laser Enable) as well as flick Output 7 on/off (laser Reset).
Edited; Also, do you have PWM enabled in the Wizard?
Edited; Also, do you have PWM enabled in the Wizard?
Scott