martyscncgarage wrote: ↑Tue Jun 14, 2022 10:28 am
Mistake, DIVIDE the pitch by the reduction
Hello everyone
Well here is problem solved it was about my position of the Switch cl86t microphones which is the same as the others but which leave from sw1 while the cl86y leave from sw3
Stupid human error
Bonjour tout le monde
Bon voila problème résolu il s'agissait de ma position des micros Switch cl86t qui est la même que les autres mais qui partent à partir de sw1 alors que les cl86y partent à partir de sw3
Erreur humaine toute bête
Attachments
Last edited by Filardo on Tue Jun 14, 2022 11:31 pm, edited 1 time in total.
Filardo wrote: ↑Tue Jun 14, 2022 11:31 pm
Could you tell me if my settings are good for the axes
If it is not better that I take other position of micro Switch
Pourriez vous me dire si mes réglages sont bon pour les axes
Si il ne vaut mieux pas que je prenne d'autres position de micro Switch
Don't understand what you are asking.
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
Filardo wrote: ↑Tue Jun 14, 2022 11:31 pm
Could you tell me if my settings are good for the axes
If it is not better that I take other position of micro Switch
Pourriez vous me dire si mes réglages sont bon pour les axes
Si il ne vaut mieux pas que je prenne d'autres position de micro Switch
Don't understand what you are asking.
I wanted to know if I stay on 4000 on the encoder or if I have to take another setting on the micro switch because the y axis motor picks up at 4200 in advance
Je voulais savoir si je reste sur 4000 sur le codeur ou si il faut que je prenne un autre réglages sur les micro Switch par ce que le moteur de axe y décroche a 4200 en avance
Stay on the 4000 if that is what is working for you. Do not understand what you mean, Y axis motor picks up at 4200
It is important to follow the drive manual and set the encoder counts per the manual.
Filardo wrote: ↑Tue Jun 14, 2022 11:31 pm
Could you tell me if my settings are good for the axes
If it is not better that I take other position of micro Switch
Pourriez vous me dire si mes réglages sont bon pour les axes
Si il ne vaut mieux pas que je prenne d'autres position de micro Switch
Don't understand what you are asking.
[/quote
Since I have a ratio of 1/2 or 2/1 I don't know.
my advances are not good in machining they are necessarily divided by 2 can you adjust this report
I looked in the manual and I can't find how to calibrate my feeds in real time
Vu que j'ai un rapport de 1/2 ou 2/1 je n'en sais rien
mes avance ne sont pas bonnes en usinage elle sont forcément divisé par 2 peut t'on régler ce rapport
J'ai regardé dans le manuel et je ne trouve pas comment étalonner mes avances en temps réel