Centroid Community CNC Support Forum

When I start cnc12 it loads in full screen with no virtual jog panel.
Even when I try to open it from the toolbar it doesn't pull up into position on the right hand side of page. When I hover over the VCP on toolbar its blank, and Grey. Thanks in advance

ALT J should turn on the virtual jog panel.

HI THERE..
Check the link....
Win.10 tablet mode...
VCP-options...
Restart computer...

ZZBOB wrote: ↑Wed Oct 27, 2021 5:11 am HI THERE..
Check the link....
Win.10 tablet mode...
VCP-options...
Restart computer...

What link are you speaking of?
I did check tablet mode.
Whats VCP options can I change?

Thanks

OK..try this...
DO a search NO KEY PAD.....

Windows is most likely in tablet mode which causes this.

Upnorth wrote: ↑Wed Oct 27, 2021 4:58 am ALT J should turn on the virtual jog panel.

This is what it looks like when I hit alt-J, there is no VCP options to select from this window- also it doesn't appear to be functional at all.

It comes up but way different

cnckeith wrote: ↑Wed Oct 27, 2021 1:40 pm Windows is most likely in tablet mode which causes this.

Never in tablet mode

ZZBOB wrote: ↑Wed Oct 27, 2021 1:21 pm OK..try this...
DO a search NO KEY PAD.....

I'm not able to access VCP options thru the vcp, because the VCP never shows up for me.

post a fresh report.zip