Hello,
I made CAD + CAM. Using a CNC router and would like to make with step 100mm 20 pcs same product from 12mm playwood sheet.
Is it possible to make massproduction in in Centroid UI or i need to make CAM with full layout?
massproduction
Moderator: cnckeith
-
- Posts: 1971
- Joined: Thu Sep 23, 2021 3:49 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 6433DB0446C1-08115074
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Germany
Re: massproduction
Manual page 164 explains the repeat function.
Regards
Uwe
Regards
Uwe
-
- Posts: 8
- Joined: Sun Oct 24, 2021 3:17 am
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: massproduction
Thanks Uwe,
I am a new one here.
Can you also send me a link of this manual?
Lauri
I am a new one here.
Can you also send me a link of this manual?
Lauri
Re: massproduction
If you are using offline CAD/CAM instead of the Intercon conversational, then Intercon's Repeat function does not apply. You will either need to do a shift and repeat via G code (see G52 and M98 in chapters 12 and 13, for example); or you will have to find out how your particular CAD/CAM software provides repeats.
-
- Posts: 8
- Joined: Sun Oct 24, 2021 3:17 am
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: massproduction
it seems that i need to make a fresh install and add intercon.
Does it lost all my machine settings if i will make new install
I use Fusion 360 but it will be nice when my CNC operator can change near the machine how many pcs he will mill.
Does it lost all my machine settings if i will make new install
I use Fusion 360 but it will be nice when my CNC operator can change near the machine how many pcs he will mill.
Re: massproduction
Intercon is installed standard. You should find it under F5/CAM from the main screen.