Emco Turret wiring
Posted: Tue Oct 19, 2021 4:32 pm
hello,
i have a small question about the wiring for my emco pcturn 55 retrofit. i found this wiring diagram in the centroid shematic database and it shows me, that the "tool position bit" and the "tool sync bit" must be connected to the D-Sub port (H6). is it possible to connect these two cables on another port? i doens`t have the room for a D-Sub connector under my acorn board=/
best regards from germany
andy
i have a small question about the wiring for my emco pcturn 55 retrofit. i found this wiring diagram in the centroid shematic database and it shows me, that the "tool position bit" and the "tool sync bit" must be connected to the D-Sub port (H6). is it possible to connect these two cables on another port? i doens`t have the room for a D-Sub connector under my acorn board=/
best regards from germany
andy