Emco Turret wiring

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

Post Reply
Andygraphy
Posts: 5
Joined: Thu Sep 16, 2021 10:38 am
Acorn CNC Controller: No
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: none

Emco Turret wiring

Post by Andygraphy »

hello,
i have a small question about the wiring for my emco pcturn 55 retrofit. i found this wiring diagram in the centroid shematic database and it shows me, that the "tool position bit" and the "tool sync bit" must be connected to the D-Sub port (H6).
Bildschirmfoto 2021-10-19 um 21.17.04.png
is it possible to connect these two cables on another port? i doens`t have the room for a D-Sub connector under my acorn board=/

best regards from germany
andy
Post Reply