hello,
i have a small question about the wiring for my emco pcturn 55 retrofit. i found this wiring diagram in the centroid shematic database and it shows me, that the "tool position bit" and the "tool sync bit" must be connected to the D-Sub port (H6).
is it possible to connect these two cables on another port? i doens`t have the room for a D-Sub connector under my acorn board=/
best regards from germany
andy
Emco Turret wiring
Moderator: cnckeith
-
- Posts: 19
- Joined: Thu Sep 16, 2021 10:38 am
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No