Post Processor Problem
Posted: Thu Oct 14, 2021 9:43 pm
Hello,
Trying to engrave a 2D logo using our new acorn controller.
Created the code in CAMBAM using cambam's centroid postprocessor.
However i am getting circles in the toolpath on some of the radiuses.
I have tried changing the acr centre mode to no avail.
Attached is a picture of the toolpath. Any ideas what could be causing this please?
Trying to engrave a 2D logo using our new acorn controller.
Created the code in CAMBAM using cambam's centroid postprocessor.
However i am getting circles in the toolpath on some of the radiuses.
I have tried changing the acr centre mode to no avail.
Attached is a picture of the toolpath. Any ideas what could be causing this please?