Hello,
Trying to engrave a 2D logo using our new acorn controller.
Created the code in CAMBAM using cambam's centroid postprocessor.
However i am getting circles in the toolpath on some of the radiuses.
I have tried changing the acr centre mode to no avail.
Attached is a picture of the toolpath. Any ideas what could be causing this please?
Post Processor Problem
Moderator: cnckeith
-
- Posts: 1
- Joined: Thu Oct 14, 2021 9:35 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: $C3FD3CA7934-0522203324
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
-
- Posts: 667
- Joined: Fri Nov 30, 2018 1:04 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Thorp WI
Re: Post Processor Problem
Perhaps attach your g-code for people to check it out. It reminds me of an issue I used to have with a ShopBot controller many years ago, and it was due to the code not being carried out with enough decimal places. Three or four decimal places would cause arc loops, but six would fix it.
Might want to take a look at the formatting of G2 G3 arcs in the post processor.
Might want to take a look at the formatting of G2 G3 arcs in the post processor.
Scott