StepperOnline DM542T (V4.0) 24v wiring, advice needed
Posted: Wed Oct 13, 2021 12:23 pm
Hi Guys,
im just starting so forgive me if i seem a bit green, its all new.
Wiring up the Acorn with a DM542T (V4.0), this version has a 5/24v selector for the control signal. Due to space constraints i cant use the DB25 header on the Acorn, I would like to use the 24v connections on H2/H3. From what i've read this is not standard but should be doable.
Currently i cant find a schematic for this configuration. I've searched the forums, some have had success but there are few details.
I did find a schematic for standard "leadshine" drives that use 5v and H2/3, attached.
Is it possible to sub 5v for 24v to the drives as seen here or are there other considerations?
Greatly appreciative of your help.
im just starting so forgive me if i seem a bit green, its all new.
Wiring up the Acorn with a DM542T (V4.0), this version has a 5/24v selector for the control signal. Due to space constraints i cant use the DB25 header on the Acorn, I would like to use the 24v connections on H2/H3. From what i've read this is not standard but should be doable.
Currently i cant find a schematic for this configuration. I've searched the forums, some have had success but there are few details.
I did find a schematic for standard "leadshine" drives that use 5v and H2/3, attached.
Is it possible to sub 5v for 24v to the drives as seen here or are there other considerations?
Greatly appreciative of your help.