Bench testing the spindle (RESOLVED)

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

Post Reply
john543
Posts: 3
Joined: Wed Oct 06, 2021 3:04 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: E06234795241-0928215226
Location: Maine

Bench testing the spindle (RESOLVED)

Post by john543 »

Hey all
Excuse any Miss spellings my M doesn't behave well.
Anyways just got my board and was setting it up per Marty's video's. After loading the spindle bench test and clicking cycle start I get a black box no writing in it but at the top it has ( Line 1 ) and (Line 16 ) flashing alternatingly <--- if that's a word.
Can't stop it or clear it except to close cnc12 mill. Unable to continue from there, any ideas?
John
Attachments
IMG_20211012_165640713.jpg
Last edited by john543 on Tue Oct 12, 2021 7:44 pm, edited 1 time in total.
cncsnw
Posts: 2254
Joined: Wed Mar 24, 2010 5:48 pm

Re: Bench testing the spindle

Post by cncsnw »

1) Press F4/Run
2) Press F10/RTG On/Off until the screen says "Run-Time Graphics: Off"
3) Press ESC to return to the main screen
4) Try running the bench test program again

With the G codes on the screen, instead of the run-time graphics display, perhaps you will be able to see why it is not proceeding.
john543
Posts: 3
Joined: Wed Oct 06, 2021 3:04 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: E06234795241-0928215226
Location: Maine

Re: Bench testing the spindle

Post by john543 »

I'll try that thanks
john543
Posts: 3
Joined: Wed Oct 06, 2021 3:04 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: E06234795241-0928215226
Location: Maine

Re: Bench testing the spindle

Post by john543 »

It worked thank you. Spindle bench test complete
Post Reply