Hey all
Excuse any Miss spellings my M doesn't behave well.
Anyways just got my board and was setting it up per Marty's video's. After loading the spindle bench test and clicking cycle start I get a black box no writing in it but at the top it has ( Line 1 ) and (Line 16 ) flashing alternatingly <--- if that's a word.
Can't stop it or clear it except to close cnc12 mill. Unable to continue from there, any ideas?
John
Bench testing the spindle (RESOLVED)
Moderator: cnckeith
-
- Posts: 48
- Joined: Wed Oct 06, 2021 3:04 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: E06234795241-0928215226
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Maine
Bench testing the spindle (RESOLVED)
Last edited by john543 on Tue Oct 12, 2021 7:44 pm, edited 1 time in total.
Re: Bench testing the spindle
1) Press F4/Run
2) Press F10/RTG On/Off until the screen says "Run-Time Graphics: Off"
3) Press ESC to return to the main screen
4) Try running the bench test program again
With the G codes on the screen, instead of the run-time graphics display, perhaps you will be able to see why it is not proceeding.
2) Press F10/RTG On/Off until the screen says "Run-Time Graphics: Off"
3) Press ESC to return to the main screen
4) Try running the bench test program again
With the G codes on the screen, instead of the run-time graphics display, perhaps you will be able to see why it is not proceeding.
-
- Posts: 48
- Joined: Wed Oct 06, 2021 3:04 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: E06234795241-0928215226
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Maine
Re: Bench testing the spindle
I'll try that thanks
-
- Posts: 48
- Joined: Wed Oct 06, 2021 3:04 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: E06234795241-0928215226
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Maine
Re: Bench testing the spindle
It worked thank you. Spindle bench test complete