Good afternoon,
newbie question,
just ran a facemill op. I want to step it down 20 thou and run it again at a slower feedrate (manual feed override)
How do I adjust my work coord system down 20 thou so I can just rerun the code?
Also, how do I manually tell it to go to home? (G0 X0 Y0 Z0)? Where can I type code in?
Thanks!
newb question, how do i rerun code 20 thou lower?
Moderator: cnckeith
-
tblough
- Posts: 3099
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
Re: newb question, how do i rerun code 20 thou lower?
The Centroid CNC12 manual is located here: https://www.centroidcnc.com/centroid_di ... -v4.20.pdf
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
-
Gary Campbell
- Posts: 2185
- Joined: Sat Nov 18, 2017 2:32 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: Yes
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: Acorn 238
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Bergland, MI, USA
- Contact:
-
Upnorth
- Posts: 237
- Joined: Wed Apr 01, 2020 8:23 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 1702
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: newb question, how do i rerun code 20 thou lower?
With the mill offset so it will not jog into the part move the head down to .020" below the original Z. Reset Z axis zero on the control panel. This is how I do it if it's only for 1 part