Page 2 of 2
Re: zero plate on old shopbot, wiring question...
Posted: Tue Sep 14, 2021 5:48 pm
by Dhaffner
That did it! With +24v connected, and making sure (machine) was connected to the ground ⏚…it lit right up! Thank you so much. I started this very little experience (other than designing parts in Vectric. I’m already a fan of Acorn and look forward to my first cut all set up!
Re: zero plate on old shopbot, wiring question...
Posted: Tue Sep 14, 2021 5:49 pm
by Dhaffner
Dhaffner wrote: ↑Tue Sep 14, 2021 5:48 pm
That did it! With +24v connected, and making sure (machine) was connected to the ground ⏚…it lit right up! Thank you so much. I started this with very little experience (other than designing parts in Vectric. I’m already a fan of Acorn and look forward to my first cut all set up! Bye bye shopbot hello Acorn!