zero plate on old shopbot, wiring question...
Moderator: cnckeith
-
- Posts: 23
- Joined: Fri Aug 20, 2021 4:54 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: zero plate on old shopbot, wiring question...
That did it! With +24v connected, and making sure (machine) was connected to the ground ⏚…it lit right up! Thank you so much. I started this very little experience (other than designing parts in Vectric. I’m already a fan of Acorn and look forward to my first cut all set up!
-
- Posts: 23
- Joined: Fri Aug 20, 2021 4:54 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: zero plate on old shopbot, wiring question...
Dhaffner wrote: ↑Tue Sep 14, 2021 5:48 pm That did it! With +24v connected, and making sure (machine) was connected to the ground ⏚…it lit right up! Thank you so much. I started this with very little experience (other than designing parts in Vectric. I’m already a fan of Acorn and look forward to my first cut all set up! Bye bye shopbot hello Acorn!