zero plate on old shopbot, wiring question...

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

Dhaffner
Posts: 23
Joined: Fri Aug 20, 2021 4:54 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No

Re: zero plate on old shopbot, wiring question...

Post by Dhaffner »

That did it! With +24v connected, and making sure (machine) was connected to the ground ⏚…it lit right up! Thank you so much. I started this very little experience (other than designing parts in Vectric. I’m already a fan of Acorn and look forward to my first cut all set up!
Dhaffner
Posts: 23
Joined: Fri Aug 20, 2021 4:54 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No

Re: zero plate on old shopbot, wiring question...

Post by Dhaffner »

Dhaffner wrote: Tue Sep 14, 2021 5:48 pm That did it! With +24v connected, and making sure (machine) was connected to the ground ⏚…it lit right up! Thank you so much. I started this with very little experience (other than designing parts in Vectric. I’m already a fan of Acorn and look forward to my first cut all set up! Bye bye shopbot hello Acorn!
Post Reply