I should just confirm this is where your referring to on the drawing. It was a bit more to th right than left, LOL so figured I would make sure?tblough wrote: ↑Sat Sep 25, 2021 7:39 am Schematic S15010 ACORN_rev4, STANDARD SYSTEM
https://www.centroidcnc.com/dealersuppo ... 010.r3.pdf
Left side in the center - "mist or clamp" shows the hookup.
My Sherline 5400 mill with Acorn control build
Moderator: cnckeith
-
- Posts: 447
- Joined: Thu Jul 15, 2021 1:43 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: My Sherline chucker lathe & 5400 mill with Acorn control build
-
- Posts: 3102
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
Re: My Sherline chucker lathe & 5400 mill with Acorn control build
Amazingly enough, I do know my right from my left. You specifically asked how to wire a solenoid, not how to connect the solenoid to the Acorn.
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.