updating my old shopbot Prt..
Moderator: cnckeith
-
- Posts: 2187
- Joined: Sat Nov 18, 2017 2:32 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: Yes
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: Acorn 238
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Bergland, MI, USA
- Contact:
Re: updating my old shopbot Prt..
You're welcome. FYI, there are a good number of other ShopBotters here that have done a DIY Acorn upgrade, a number of them using the Gecko 203
-
- Posts: 23
- Joined: Fri Aug 20, 2021 4:54 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: updating my old shopbot Prt..
I had the 48v power supply hooked up wrong, but once I connected it to positive and negative..gecko lit up and cnc12 move x command started the motor right up! This is going to work..even on these old motors. All the videos and documentation have been a huge help so far. I was very worried when the shopbot motherboard died...and now, with this working, I feel in control again. Thanks for the help and links...