Hi all,
I have a 3axes milling setup with Acorn rev3 and Gecko G201X drives. Although everything works generally OK, that was still my first build of the cabinet, there are also some glitches, and I would like to rebuild it - this time with closed loop drivers/motors. Leadshine H2-758 drivers came to my attention as an interesting all in one solution with fan. Does anyone have experience with those? Should I be concerned about anything?
Also I am interested in potentially using DB25 interface this time. Does anyone know of a breakout board solution that works like 1x DB25 in to 3xDB25 out that would be compatible with Acorn's pinout? I understand that I'd probably need to mangle with pinout of the cables going to drives.
Many thanks,
Bruno
Experience with Leadshine H2-758
Moderator: cnckeith
-
- Posts: 7306
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Contact:
Re: Experience with Leadshine H2-758
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html