martyscncgarage wrote: ↑Mon Aug 09, 2021 6:34 pm
Then you had a closure of that enable circuit. Are you sure you are on NORMALLY OPEN contact on Acorn relay board?
I will double check inside the Wizard that I have the right state chosen for output 4 & 5.
Third time is the charm. I had two bad KBMG-212D controller bought from ebay. The 3rd was new and works like a charm. This motor is very quite. Now I can move on with the rest of the restoration.
Thank you Marty for being so patient and helping me trouble shoot the problem. It was just bad luck (and a bit of frugality) that kept me from getting a good driver.
Bill Griggs wrote: ↑Sat Aug 28, 2021 8:12 pm
SUCCESS!!!
Third time is the charm. I had two bad KBMG-212D controller bought from ebay. The 3rd was new and works like a charm. This motor is very quite. Now I can move on with the rest of the restoration.
Thank you Marty for being so patient and helping me trouble shoot the problem. It was just bad luck (and a bit of frugality) that kept me from getting a good driver.
Onward!
Good to hear Bill
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ