Beaglebone heartbeat (Self Resolved)
Moderator: cnckeith
-
curiousMike
- Posts: 75
- Joined: Tue Sep 24, 2019 3:05 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Beaglebone heartbeat (Self Resolved)
I have one the boards with a dual function led "heatrbeat". At present I have a blue light on the beagle board that is not blinking but the "dual purpose" light on the acorn board is blinking between two colors... red/green. What does this mean?
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
curiousMike
- Posts: 75
- Joined: Tue Sep 24, 2019 3:05 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Beaglebone heatbeat
Problem resolved. I was looking at the blue light on wrong side of the ethernet adapter.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)