Hi All:
I'm using Centroid Acorn on a PM-728VT with Clearpath servo's.
I've seen several video's where thy seem to mention a jog increment
of .0001. In my setup, the smallest increment I have is
.001". Is there a way to have .0001"? It would be handy to have
when using a touch probe and close work.
Thanks
RonL
Jog increments
Moderator: cnckeith
-
- Posts: 231
- Joined: Mon Feb 07, 2011 8:03 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 1030090103
- DC3IOB: Yes
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: No
- Location: Montvale, NJ
Re: Jog increments
Check parameter #40. It holds the control's basic jog increment size. Default is .0001" and will jog that amount with the X1 jog key.
-
- Posts: 368
- Joined: Tue Dec 11, 2018 4:03 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: F045DA80C8B8-0905181172
E415F6F70BC3-0318203049
98F07B91FC6B-0123236802 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: UK
Re: Jog increments
Simplest and preferred method with Acorn is to use the Wizard - Go to the Axis configuration section and enter your requirement (i.e. 0.0001) in the x1 Linear Jog Increment box.
Whilst in the Wizard, also review the Touch Devices - Probe and change as required
hope this helps
Whilst in the Wizard, also review the Touch Devices - Probe and change as required
hope this helps
Hope this helps
Nigel
"You can lead a horse to water but you cannot force it to drink"
Nigel
"You can lead a horse to water but you cannot force it to drink"