Centroid Community CNC Support Forum

I always have visions of disaster when I do an upgrade. LOL Saved working 6.2, did screen shots, ran the upgrade. Seemed to load after getting the ip address reset. Restored the working 6.2 report. Wisard looked good except wasn't able to access drives (grayed out) all else looked good. Restored license. Motors ran ok, Y axis looked off slightly. Then noticed that the VCP was the old configuration, not the new version.

Any Ideas on how to recover this? Maybe reinstall and hope for better results?

Thanks,

Fixed with reinstall and selecting "Update Wizard" option when starting the Wizard. Now just have to update the VCP button functions.

I assume you meant 4.64 version upgrade?

LOL yes Marty, I meant 4.64 upgrade. Getting old at 76 I guess.