Need help on wiring diagram for KL 5080D4 fo Acron
thanks Larry
KL 5080D4
Moderator: cnckeith
-
swissi
- Posts: 573
- Joined: Wed Aug 29, 2018 11:15 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 985DADEB24D5-0309180716
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
Re: KL 5080D4
If you are using Fusion 360, check out my CNC12 specific Post Processor
If you are using a Touch Probe, Tool Touch Off Device or a Triple Corner Finder Plate, check out my ProbeApp
Contact me at swissi2000@gmail.com
If you are using a Touch Probe, Tool Touch Off Device or a Triple Corner Finder Plate, check out my ProbeApp
Contact me at swissi2000@gmail.com
-
ShawnM
- Posts: 2214
- Joined: Fri May 24, 2019 8:34 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 7804734C6498-0401191832
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Clearwater, FL
Re: KL 5080D4
Just wire up the PUL and DIR per the Leadshine diagram first and see if you get movement. Most time the ENA lines are not needed as the drive is enabled by default. After you get it working them you can wire up the ALM to an input to monitor the drives. Get ONE drive working all by itself first and them move on to the next one and then the third. It's best to not hook them all up at once, get one drive at a time wired and moving, it'll save you many headaches.
-
Iflyb777
- Posts: 30
- Joined: Wed May 12, 2021 8:48 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 0035FF98C2BC-0421214705
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Beloit , Ks
Re: KL 5080D4
Thanks