Sorry for the delay. Here is a resent video on YouTube with the issues. Now it is in the x and y axis. The only way I can describe the problem is that it is losing steps. The problem is coming and going in all the drives and showed up right after I updated the software to CNC12 v4.64.
I also attached all the reports I did that correspond to the video time stamps to this post.
Any help would be greatly appreciated.
Have a good Memorial day.
Re: Gremlins
Posted: Sun May 30, 2021 2:51 pm
by martyscncgarage
No need to post all the reports. Only a fresh one and maybe one from the previous version.
Did you do a FRESH install and hand copy in all your machine settings or did you restore from an older report?
Re: Gremlins
Posted: Sun Jun 20, 2021 8:17 am
by Gmachine
After not finding anything wrong with my connections or wiring I moved forward with wiping cnc 12 and starting over with fresh install. Immediately after the installation and rehoming the machine I could tell it was working properly. I ran my machine for 4 hours on 6/19/21 with not problems. My guess is that a file was corrupted during installation causing my issues. In the future if someone has issues after an update. Tell them to reinstall the software before jumping to conclusions.
Re: Gremlins
Posted: Sun Jun 20, 2021 9:46 am
by martyscncgarage
Gmachine wrote: ↑Sun Jun 20, 2021 8:17 am
After not finding anything wrong with my connections or wiring I moved forward with wiping cnc 12 and starting over with fresh install. Immediately after the installation and rehoming the machine I could tell it was working properly. I ran my machine for 4 hours on 6/19/21 with not problems. My guess is that a file was corrupted during installation causing my issues. In the future if someone has issues after an update. Tell them to reinstall the software before jumping to conclusions.
I recommend starting with a fresh cleaning install, using Wizard screen shots from the last installation. NOT using Restore Report from an older version if you are having trouble.