Pulse and Direction negative go to the acorn board.
Pulse and Direction Positive go to 24v.
---------- you need to add a 1.5-2k ohm resistor between step/direction positive and 24v.
All good now!!!
Centroid Acorn with servos? New build: Novakon Torus Pro
Moderator: cnckeith
-
CivilCNC
- Posts: 68
- Joined: Wed Apr 07, 2021 11:16 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: will obtain
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Centroid Acorn with servos? New build: Novakon Torus Pro
Got the acorn communication with the 220v maxsine servo drivers all figured out.
Pulse and Direction negative go to the acorn board.
Pulse and Direction Positive go to 24v.
---------- you need to add a 1.5-2k ohm resistor between step/direction positive and 24v.
All good now!!!
Pulse and Direction negative go to the acorn board.
Pulse and Direction Positive go to 24v.
---------- you need to add a 1.5-2k ohm resistor between step/direction positive and 24v.
All good now!!!