Post a picture of your control cabinet as well please.JunkfoodGuy wrote: ↑Wed May 05, 2021 12:52 pm Yeah, lots of circles. They have a ramp too.
I have seen some improvement by re-running the x axis auto tune and copying that to the Y axis. I feel the Y is where my issue remains.
Circles looking much better but will go out of round if I push past 100% feedrate. I'm going to run a full 4x8 sheet and check the results.
ill post a report after that is done
Circles look like potatoes
Moderator: cnckeith
-
- Posts: 9914
- Joined: Tue Mar 28, 2017 12:01 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Location: Mesa, AZ
Re: Circles look like potatoes
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
We can't "SEE" what you see...
Mesa, AZ
-
- Posts: 2226
- Joined: Fri May 24, 2019 8:34 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 7804734C6498-0401191832
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Clearwater, FL
Re: Circles look like potatoes
I cut A LOT of HDPE (3/8" and 3/4") and it cuts like butter. No real need for ramps and you can easily set the depth of cut to the bit diameter. I can cut 3/4" sheets in two passes with a good O flute bit from Amana. Maybe your machine is not as rigid as I think it is. Sounds like a motor setup issue maybe, not sure.
-
- Posts: 5
- Joined: Sun Apr 25, 2021 8:51 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 4484
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Circles look like potatoes
Yeah I agree. As I said in my first post, the nema 34 steppers were solid at this. Just lost steps once in a while.
I have pulled all my upgrades off, going back to my steppers for now. Will try again in the future when I have more time.
I have pulled all my upgrades off, going back to my steppers for now. Will try again in the future when I have more time.