Page 1 of 1

Tool Trail

Posted: Tue Apr 06, 2021 10:24 am
by machfab
Anyone know how to get the Tool Trail to display in a 2 axis configuration?
This is on a waterjet
Tool Trail not showing
Thanks

Re: Tool Trail

Posted: Tue Apr 06, 2021 12:24 pm
by tblough
You need to specify a tool diameter.

Re: Tool Trail

Posted: Tue Apr 06, 2021 12:45 pm
by martyscncgarage
As Tom mentioned, you need to setup Tool 1 in the Tool Library and give it a diameter. Perhaps the diameter of the water jet stream
F1 Setup
F2 Tool
F1 Offset Library
F2 Tool Library

Read up in the Mill Operator's Manual:
https://www.centroidcnc.com/centroid_di ... -v4.14.pdf