ProLight 3000 turning center retrofit (Build Log)

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

Post Reply
AcornJosh
Posts: 72
Joined: Tue Apr 17, 2018 8:58 am
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: none

ProLight 3000 turning center retrofit (Build Log)

Post by AcornJosh »

I am retrofitting a prolight 3000 turning center to Acorn w/ Leadshine closed loop steppers. This machine has a 4 position tool turret.
overall.jpg
Machine is setup for Nema 23 with 1/4 diameter shafts. The stock motors are 2.9 amp open loop steppers. You could run these from a stepper drive but I have elected to replace them with leadshine CS-M22323-S closed loop steppers and CS-D1008 Drives. This stepper motor is short enough to fit within the X axis enclosure. The CS-D508 drive is the ideal match for these motors but I already have CS-D1008 drives on hand. The CS-D1008 can accept AC bus voltage meaning I only need a step down transformer which I have on hand.
motor.jpg
The lathe has some kind of built in speed control. It also has something that looks like an encoder or tachometer. I will try to reuse these parts if possible. I might gut the enclosure and relocate these parts to the cabinet to make it easier to work on.
spindlecontrol.jpg
When requesting support READ THIS POST first. viewtopic.php?f=60&t=1043

Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.

(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
Post Reply