Keith... The 24V connection did the trick. When I power up the board and the leds for the port my mind skiped over the 24V connection. Thanks abundle
I have a new question but will do a new post Thanks Mike
back to basics
Moderator: cnckeith
-
- Posts: 63
- Joined: Tue Sep 24, 2019 3:05 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
-
- Posts: 9914
- Joined: Tue Mar 28, 2017 12:01 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Location: Mesa, AZ
Re: back to basics
Its very unnerving to me to see bare wires and loose wires around PCB boards.
As previously stated YOU must supply 24VDC to ONE of the to terminals MARKED 24VDC on the input terminal blocks (Far left)
None of the inputs will work without it.
Which input is Estop? Take a jumper from Acorn power supply COM and touch it to that input while watching the input on the DIAGNOSTIC screen (Alt i)
As previously stated YOU must supply 24VDC to ONE of the to terminals MARKED 24VDC on the input terminal blocks (Far left)
None of the inputs will work without it.
Which input is Estop? Take a jumper from Acorn power supply COM and touch it to that input while watching the input on the DIAGNOSTIC screen (Alt i)
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
We can't "SEE" what you see...
Mesa, AZ
-
- Posts: 9914
- Joined: Tue Mar 28, 2017 12:01 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Location: Mesa, AZ
Re: back to basics
Glad your resolved your Estop issue.curiousMike wrote: ↑Tue Mar 09, 2021 10:07 am Keith... The 24V connection did the trick. When I power up the board and the leds for the port my mind skiped over the 24V connection. Thanks abundle
I have a new question but will do a new post Thanks Mike
PLEASE keep your posts in ONE thread.
Marty
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
We can't "SEE" what you see...
Mesa, AZ