Title says it all. Would the computer linked below be enough to run an Acorn properly? The CPU is a dual core 4.0 GHZ, SSD, 8 GB DDR4. How do I know if the ethernet is shielded?
https://www.bestbuy.com/site/hp-desktop ... Id=6420306
Would this computer get it done (AVID 4x8)
Moderator: cnckeith
-
- Posts: 29
- Joined: Thu Feb 11, 2021 9:16 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: No
- CNC11: No
- CPU10 or CPU7: No
-
- Posts: 2214
- Joined: Fri May 24, 2019 8:34 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 7804734C6498-0401191832
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Clearwater, FL
Re: Would this computer get it done (AVID 4x8)
Here's a link to the Acorn minimum PC requirements: https://www.centroidcnc.com/cnc_pc_perf ... ments.html
The computer you linked to does meet the minimum requirements. Centroid requires you to use a shielded cable and one is provided in the Acorn kit. The port on most pc's is a shielded port but that's not what are referring to in the minimum specs.
The computer you linked to does meet the minimum requirements. Centroid requires you to use a shielded cable and one is provided in the Acorn kit. The port on most pc's is a shielded port but that's not what are referring to in the minimum specs.
-
- Posts: 29
- Joined: Thu Feb 11, 2021 9:16 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: No
- CNC11: No
- CPU10 or CPU7: No
Re: Would this computer get it done (AVID 4x8)
Good deal. I figured it did. I saw the one they were selling for 1100 and was concerned. Thanks for the input on the cable. I know the ones with the metal sides are typically shielded. I just have never noticed that spec'd on a motherboard before.