Eric gives us an update on his Acorn ATC setup. Nice work!
Eric gives us an update on his Acorn ATC setup.
Moderator: cnckeith
-
- Posts: 3117
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- MPU11 & GPIO4D -w/ 3rd Party Drives: Yes
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- CNC Control System Serial Number: none
- Contact:
Eric gives us an update on his Acorn ATC setup.
When requesting support READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
-
- Posts: 10
- Joined: Tue Dec 22, 2020 1:48 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- MPU11 & GPIO4D -w/ 3rd Party Drives: No
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- CNC Control System Serial Number: 0035FF8A2978-1009203821-MPU12-System
Re: Eric gives us an update on his Acorn ATC setup.
This is very nice to hear.
With ATCs becoming more affordable and this sort of documentation I could foresee myself buying one someday.
With ATCs becoming more affordable and this sort of documentation I could foresee myself buying one someday.