What do YOU use the WMPG macro buttons for?

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

Post Reply
ChrisAttebery
Posts: 74
Joined: Mon Dec 07, 2020 2:20 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: 4031
Location: Gilroy, CA
Contact:

What do YOU use the WMPG macro buttons for?

Post by ChrisAttebery »

I'm curious what everyone uses the WMPG macro buttons for.

So far I have the following:
Macro1 - G28 (Tool Change Position. Z machine zero, X machine zero - centered on TLO, Y centered on TLO)
Macro2 - G30 (Part loading position. Z machine zero, X centered on vise, Y table all the way forward)
Macro3 - Unused
Macro4 - Z machine zero, X WCS zero, Y WCS zero

What macros have you tied into the WMPG?
Post Reply