Please Help!! (Resolved)
Posted: Tue Jan 12, 2021 9:58 pm
Anyone's help would be greatly appreciated!
Here's the issue. I am trying to run this F360 program on my Acorn CNC12 Ver4.14.
I keep getting an "Abnormal Job End" after I load the program and then try to Run it. I have always used F360 with success until now. I have a subscription as well.
Here's what I've done to diagnose it so far so this is all I can tell you.
1: I have made a CAM program using INTERCON and that works fine
2: I have loaded previous Fusion 360 programs from the directory and they run as well.
3: I have gone into F360, post processed the same earlier project, but the NEW copy does not work! I look at them in Notepad and they are identical!
4: I have made a simple CAM in F360 thinking maybe my program was to intense for ACORN. That works.
So here we are. Acorn seems to work but there seems a varying degree of uncertainty around Fusion 360.
I have also reloaded the Centroid post processor from Autodesk.
If anyone can look at or load this program to see what result they get, anything would be appreciated. I know that sounds shady loading a program but Im at my wits end try to get this to work.
Thank you for any input in advance.
Doug
Here's the issue. I am trying to run this F360 program on my Acorn CNC12 Ver4.14.
I keep getting an "Abnormal Job End" after I load the program and then try to Run it. I have always used F360 with success until now. I have a subscription as well.
Here's what I've done to diagnose it so far so this is all I can tell you.
1: I have made a CAM program using INTERCON and that works fine
2: I have loaded previous Fusion 360 programs from the directory and they run as well.
3: I have gone into F360, post processed the same earlier project, but the NEW copy does not work! I look at them in Notepad and they are identical!
4: I have made a simple CAM in F360 thinking maybe my program was to intense for ACORN. That works.
So here we are. Acorn seems to work but there seems a varying degree of uncertainty around Fusion 360.
I have also reloaded the Centroid post processor from Autodesk.
If anyone can look at or load this program to see what result they get, anything would be appreciated. I know that sounds shady loading a program but Im at my wits end try to get this to work.
Thank you for any input in advance.
Doug