Guys.
Is there a way to move the location of a button on the VCP screen? I think the tool check button is in a really bad location. If you are hitting the +X button on a lathe setup and accidentally hit tool check bad things happen. Is there a way to move this button to a safer area so you can't accidentally hit it?
Thanks
Tool Check button issue (Resolved)
Moderator: cnckeith
-
cnckeith
- Posts: 2993
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- MPU11 & GPIO4D -w/ 3rd Party Drives: Yes
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- CNC Control System Serial Number: none
- Contact:
Re: Tool Check button issue
When requesting support READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
-
vw_chuck
- Posts: 49
- Joined: Sun Sep 20, 2020 7:34 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- MPU11 & GPIO4D -w/ 3rd Party Drives: No
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- CNC Control System Serial Number: 0035FF8FEB5F-0708203490
Re: Tool Check button issue
Ah very good. Thanks