No chance of connecting those, I have been on the phone with Tecknic and I must say that they are top notch folk. I may be sending mine in for repairs as they did not pass the battery test which leads me to believe that they are my issueRichards wrote: ↑Tue Jan 05, 2021 4:18 pm Smoke is never a good sign. We call it "letting out the magic blue smoke". Is there any chance that you connected H1-Voltage IN or H4-Voltage IN to H2-Common? The Common signal is next to Step-2.
Here's a screen shot of page 47 of the Teknic ClearPath manual that shows where to add the resistors.
ClearPath_Resistor.png
VFD Interference with Clearpath Servos
Moderator: cnckeith
-
- Posts: 28
- Joined: Fri Mar 27, 2020 12:40 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No