WCS zero X and Y macro

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

Nigelo
Posts: 97
Joined: Tue Dec 11, 2018 4:03 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: F045DA80C8B8-0905181172
E415F6F70BC3-0318203049
Location: UK

Re: WCS zero X and Y macro

Post by Nigelo »

routebot wrote: Thu Jan 07, 2021 12:52 pm
Nigelo wrote: Sat Jan 02, 2021 9:07 am Unless I am missing something and you have used all available WCS depending on your licensing, why not allocate one (e.g. WCS6) just for the jig. Then you are ready to go as and when required but still retaining the flexibility of the other WCS settings for other work. Advantage is no programing required
I need to look into this. If I can save a WCS that would be perfect. CNC12 is new to me and I have a lot to learn!!
See chapter 4 of the Mill Operator's manual - section 4.2 shows how to set up WCS. You can download the manual on link https://www.centroidcnc.com/centroid_di ... loads.html then scroll down to the All-in-One section in lime green and look for "CNC12 Mill Operators Manual"
Post Reply